/// SUPPORTED THIRD-PARTY PLUGIN

Quick Smelt

Free guide for configuring this third-party plugin in the Hub. Install the plugin separately from its official source.

Version: 5.1.5
Framework: oxide
Target file: oxide/config/QuickSmelt.json

Open configurator →View configuration page →View the official source ↗

Prepare your file

Check the installed version
This guide describes Quick Smelt 5.1.5. Use the same version in the configurator.
Import your configuration
Open the configurator and import your current JSON. For a new installation, you can start from the provided example.
Edit and download
Adjust the settings, fix reported errors, and download the JSON. Keep a copy of your old file before replacing it.

Your configuration is not saved on the site. Keep the exported file; you can import it again later.

Settings for this version

General 9

Use permission: On / off · required
Apply Quick Smelt only to furnaces owned by players with quicksmelt.use.
JSON path
Use Permission
Smelting speed multipliers: JSON value · required
Set a smelting-speed multiplier for each oven short name; global applies when no specific value exists.
JSON path
Speed Multipliers
Fuel burn-speed multipliers: JSON value · required
Set how quickly each oven type consumes fuel.
JSON path
Fuel Usage Speed Multipliers
Fuel usage multipliers: JSON value · required
Set the amount of fuel consumed by each oven type.
JSON path
Fuel Usage Multipliers
Output multipliers: JSON value · required
Set output multipliers by oven type and item short name.
JSON path
Output Multipliers
Input whitelist: JSON value · required
List the item short names each oven type is allowed to smelt.
JSON path
Whitelist
Input blacklist: JSON value · required
List the item short names each oven type must refuse.
JSON path
Blacklist
Smelting frequencies: JSON value · required
Set how often each oven type processes a smelting cycle.
JSON path
Smelting Frequencies (Smelt items every N smelting ticks)
Debug logging: On / off · required
Enable verbose diagnostic logging.
JSON path
Debug

Plugin instructions

Quick Smelt 5.1.5

Quick Smelt changes furnace processing speed, fuel use, output, and accepted inputs. It has no required plugin dependency and runs on Oxide. When Use Permission is true, grant quicksmelt.use to the players whose furnaces should use these rules.

Configuration

Speed Multipliers changes how frequently each oven processes items. Fuel Usage Speed Multipliers changes how fast fuel burns, while Fuel Usage Multipliers changes the amount consumed.
Output Multipliers is a two-level dynamic map: oven shortname, then output item shortname. global can act as a fallback at either level.
Whitelist and Blacklist are dynamic oven maps containing input item shortnames, not output items. Review overlaps deliberately.
Smelting Frequencies (Smelt items every N smelting ticks) processes items every Nth smelting tick; larger values make processing slower and less frequent.
Debug enables diagnostic logging and should normally remain false.

All maps are intentionally lossless JSON because server owners replace placeholder keys such as furnace.shortname and item.shortname with arbitrary Rust shortnames (furnace, furnace.large, campfire, and so on). The pinned source does not validate multiplier signs or frequency bounds. Zero, negative, or extreme multipliers/frequencies can cause broken balance, excessive production, unexpected fuel behavior, or runtime arithmetic problems; test a complete ruleset off production.

Target file: oxide/config/QuickSmelt.json.

Install the file

After keeping a copy of the previous file, place the exported JSON at this location on your server:

oxide/config/QuickSmelt.json

Follow the plugin instructions above for dependencies and reloading. Exporting does not connect the site to your server.